2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Speed Signal Circuit

Circuit diagnosis · Vehicles built from Jun 2009

DESCRIPTION

The clearance warning ECU assembly receives a vehicle speed signal from the combination meter.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM

E192288E01

INSPECTION PROCEDURE


1. CHECK METER / GAUGE SYSTEM
  1. The circuits that send vehicle speed signals to this system are inspected in the meter system (Click here).

  1. During inspection for the meter section, if there is an instruction that indicates to go back inspections for each system, proceed to the next step.


NEXT


2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - COMBINATION METER)

  1. E196857E01
    Disconnect the O30 clearance warning ECU connector and the F1 combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O30-3 (SPD) - F1-11 (+S)
    Always
    Below 1 Ω

Text in Illustration 
*1
Rear view of wire harness connector
(to Clearance Warning ECU Assembly)
*2
Rear view of wire harness connector
(to Combination Meter Assembly)


NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - NO. 3 JUNCTION BLOCK)
  1. Disconnect the No. 3 junction block connector.

  1. Measure the resistance according to the value(s) in the table below.E142504E02

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O30-3 (SPD) - 3T-10
    Always
    Below 1 Ω

Text in Illustration 
*1
Rear view of wire harness connector
(to No. 3 Junction Block)
*2
Rear view of wire harness connector
(to Clearance Warning ECU Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU (CLEARANCE WARNING ECU - NO. 3 JUNCTION BLOCK)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (NO. 3 JUNCTION BLOCK)


← Park / Neutral Position Switch Circuit (from Jun 2009)Back Sonar Sensor Circuit (from Jun 2009) →