Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (for 6 Sensor Type)
Clearance Warning Buzzer Circuit
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The clearance warning buzzer sounds using pulse signals sent from the clearance warning ECU assembly. The buzzer sounds to alert the driver and the buzzer frequency changes depending on the distance to an obstacle. WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE WARNING BUZZER)
Disconnect the O30 ECU connector.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
O30-10 (BBZ) - F30-1
Always
Below 1 Ω
O30-11 (EF) - F30-2
Below 1 Ω
O30-10 (BBZ) - Body ground
10 kΩ or higher
O30-11 (EF) - Body ground
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
2. INSPECT CLEARANCE WARNING BUZZER
Remove the clearance warning buzzer (Click here for LHD, Click here for RHD).
Apply battery voltage and check the operation of the warning buzzer, as shown in the table below.
OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2
Operating sound occurs
HINT:
The clearance warning buzzer does not sound when battery voltage is applied because the buzzer is a separately-excited type.
NG
REPLACE CLEARANCE WARNING BUZZER
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here )