2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

B2452 Height Control Sensor Data Out of Range When Initializing

Diagnostic trouble codes · Vehicles built from Jun 2009

DESCRIPTION

The AFS ECU stores this DTC if the sensor value received from the height control sensor is out of range when performing initialization of the AFS ECU; for example, the vehicle is not level or being jacked up.
DTC No.
DTC Detecting Condition
Trouble Area
B2452
Vehicle condition not specified when initializing
  1. Vehicle condition when initializing
  2. AFS ECU

INSPECTION PROCEDURE


1. PERFORM INITIALIZATION
  1. Perform initialization of the AFS ECU (Click here).

    HINT:
    1. Before initializing, make sure that the vehicle condition is proper for initialization.
    2. Be sure to perform the initialization as instructed.


NEXT


2. RECHECK FOR DTC
  1. Using the intelligent tester, recheck for DTCs.

    Result:
    Result
    Proceed to
    DTC B2452 is not output.
    A
    DTC B2452 is output.
    B

    HINT:
    If the AFS ECU stores DTC B2452 even though the ECU has been initialized as instructed, there may be a malfunction in the AFS ECU.



B
REPLACE AFS ECU
A

END


← B2450 Initialization has not been Performed (from Jun 2009)Ignition Switch Circuit (from Oct 2006) →