2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Vehicle Battery Voltage

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Battery voltage is applied to the mayday ECU terminal 3. If the battery voltage falls below a preset voltage for longer than 30 minutes, the mayday ECU will transmit a Low Battery alert to the Toyota Link Call Centre.
If the battery is removed, the mayday ECU will transmit a Low Battery alert to the Toyota Link Call Centre.
For further information, refer to ALERTS - Low Battery Voltage Alert (Click here).

INSPECTION PROCEDURE


1. CHECK BATTERY VOLTAGE
  1. Using a digital multimeter, measure the vehicle battery voltage.

    OK:
    12 - 14 V



NG
FAULTY BATTERY OR CHARGING SYSTEM (Click here)
OK


2. CHECK BATTERY VOLTAGE USING TDT
  1. Check battery voltage using the TDT.

  1. Using the TDT, select: System Menu / Diagnosis / Data List.

  1. Scroll to Vehicle Battery Voltage.

    OK:
    12 - 14 V



OK
VEHICLE BATTERY OK
NG


3. CHECK BATTERY VOLTAGE AT MAYDAY ECU

  1. B169476E01
    Connect a digital multimeter between mayday ECU unit connector N46 terminal 3 and ground.

  1. Check for voltage.

    OK:
    12 - 14 V



OK
Go to step 5
NG


4. CHECK THE VOLTAGE AT THE MAYDAY FUSE
  1. Connect a digital multimeter between the MAYDAY/TEL fuse and ground.

  1. Measure the voltage.

    OK:
    12 - 14 V



OK
REPAIR OPEN CIRCUIT IN THE WIRE HARNESS TO THE MAYDAY ECU
NG

DIAGNOSE FUSE CIRCUIT

5. CHECK MAYDAY ECU GROUND

  1. B169476E01
    Connect a digital multimeter between mayday ECU unit connector N46 terminal 4 and ground.

  1. Check for continuity.

    OK:
    Less than 1 Ω



NG
REPAIR OPEN CIRCUIT IN GROUND CIRCUIT
OK


6. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


7. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← Status Indicator LEDs Do Not Illuminate (from Oct 2006)Back-up Battery (Oct 2006 – May 2009) →