2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Back-up Battery

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The back-up battery is housed in the battery compartment of the mayday ECU. The back-up battery will provide power to the mayday ECU for at least 30 minutes in the event of the vehicle battery being discharged or disconnected.
The mayday ECU has a back-up battery charging circuit that maintains the back-up battery state of charge. This circuit also includes an over current protection device.

INSPECTION PROCEDURE


1. CHECK VEHICLE BATTERY VOLTAGE
  1. Check battery voltage using the TDT.

  1. Using the TDT, select: System Menu / Diagnosis / Data List.

  1. Scroll to Vehicle Battery Voltage.

    OK:
    12 - 14 V



NG
FAULTY BATTERY OR CHARGING SYSTEM (Click here)
OK


2. CHECK BACK-UP BATTERY VOLTAGE
  1. Using the TDT, select System Menu / Diagnosis / Data List.

  1. Scroll to Back-up battery voltage.

    OK:
    7.5 - 9.8 V



NG
Go to step 6
OK


3. CHECK BATTERY CHARGER
  1. Using the TDT, select System Menu / Diagnosis / Data List.

  1. Scroll to Back-up battery Charger.

  1. Does the back-up battery charger display "Active"?



YES
Go to step 5
NO


4. CHECK BATTERY CHARGER, ENGINE RUNNING
  1. Start the engine and increase the engine speed to 2000 rpm.

  1. Using the TDT, select System Menu / Diagnosis / Data List.

  1. Scroll to Back-up battery Charger.

  1. Does the Back-up battery charger display "Active"?



NO
Go to step 6
YES


5. CHECK BATTERY CHARGER, ENGINE STATIONARY
  1. Turn the engine switch on (IG).

  1. Using the TDT, select System Menu / Diagnosis / Data List.

  1. Scroll to Back-up battery Charger.

    OK:
    Between 7.5 V and 9.8 V



OK
BACK-UP BATTERY AND CHARGING CIRCUIT OK
NG


6. CHECK BACK-UP BATTERY VOLTAGE
  1. Remove the mayday ECU (Click here).

  1. Remove the back-up battery.

  1. Connect a digital multimeter between the terminals of the back-up battery.

  1. Measure the voltage.

    OK:
    Between 7.5 V and 9.8 V



OK
Go to step 8
NG


7. CHECK BACK-UP BATTERY CONNECTOR
  1. Check the back-up connector retention.

  1. Is the connector tight?



NO
REPAIR OR REPLACE THE CONNECTOR
YES


8. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


9. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← Vehicle Battery Voltage (from Oct 2006)Back-up Battery (from Jun 2009) →