Home › BODY ELECTRICAL › CELLULAR COMMUNICATION › TOYOTA LINK SYSTEM
Back-up Battery
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The back-up battery is housed in the battery compartment of the mayday ECU. The back-up battery will provide power to the mayday ECU for at least 30 minutes in the event of the vehicle battery being discharged or disconnected. The mayday ECU has a back-up battery charging circuit that maintains the back-up battery state of charge. This circuit also includes an over current protection device. INSPECTION PROCEDURE
1. CHECK VEHICLE BATTERY VOLTAGE
Check battery voltage using the TDT.
Using the TDT, select: System Menu / Diagnosis / Data List.
Scroll to Vehicle Battery Voltage.
OK:
12 - 14 V
NG
OK
2. CHECK BACK-UP BATTERY VOLTAGE
Using the TDT, select System Menu / Diagnosis / Data List.
Scroll to Back-up battery voltage.
OK:
7.5 - 9.8 V
NG
OK
3. CHECK BATTERY CHARGER
Using the TDT, select System Menu / Diagnosis / Data List.
Scroll to Back-up battery Charger.
Does the back-up battery charger display "Active"?
YES
NO
4. CHECK BATTERY CHARGER, ENGINE RUNNING
Start the engine and increase the engine speed to 2000 rpm.
Using the TDT, select System Menu / Diagnosis / Data List.
Scroll to Back-up battery Charger.
Does the Back-up battery charger display "Active"?
NO
YES
5. CHECK BATTERY CHARGER, ENGINE STATIONARY
Turn the engine switch on (IG).
Using the TDT, select System Menu / Diagnosis / Data List.
Scroll to Back-up battery Charger.
OK:
Between 7.5 V and 9.8 V
OK
BACK-UP BATTERY AND CHARGING CIRCUIT OK
NG
6. CHECK BACK-UP BATTERY VOLTAGE
Remove the mayday ECU (Click here ).
Remove the back-up battery.
Connect a digital multimeter between the terminals of the back-up battery.
Measure the voltage.
OK:
Between 7.5 V and 9.8 V
OK
NG
7. CHECK BACK-UP BATTERY CONNECTOR
Check the back-up connector retention.
Is the connector tight?
NO
REPAIR OR REPLACE THE CONNECTOR
YES
8. CHECK MAYDAY ECU WIRE HARNESS
Disconnect the mayday ECU connectors A and B.
Check for continuity between the mayday ECU unit connector N46 and connectors A and B.
OK:
Less than 1 Ω
NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK
9. CHECK MAYDAY ECU CONNECTORS
Are the mayday ECU connectors tight?
NO
REPAIR OR REPLACE THE CONNECTORS
YES