2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL28 Key pad Circuit Power Short To Ground

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

The mayday ECU key pad is a resistor-encoded switch, which means that each button has a separate and different value resistor connected to it.
The mayday ECU uses a voltage divider circuit to determine which button has been pressed.
The ECU supplies a 12 V signal voltage to the roof console box connector on terminal +B. Whenever a button is pressed, the corresponding switch is closed and is connected to ground through a resistor.
The mayday ECU monitors the voltage which will change when any of the buttons are pressed. During the mayday ECU self test, the key pad circuit voltage is measured to detect voltage. This self-test is only performed once whenever the mayday ECU is powered up, at this time the power to the key pad is off.
DTC TL28 is set if the key pad circuit voltage is less than 1.6 V when the supply is enabled.

INSPECTION PROCEDURE


1. CHECK MAYDAY ECU VOLTAGE

  1. B169483E01
    Turn the engine switch off.

  1. Disconnect the mayday ECU unit connector N46.

  1. Connect a digital multimeter between terminal 20 and ground.

  1. Turn the engine switch on (IG) and check for voltage.

    OK:
    Less than 12 - 14 V



NG
Go to step 3
OK


2. CHECK ROOF CONSOLE BOX VOLTAGE

  1. B169476E01
    Connect the mayday ECU unit connector N46.

  1. Disconnect the roof console box connector Q16.

  1. Connect a digital multimeter between terminal 13 and ground.

  1. Turn the engine switch on (IG) and check for voltage.

    OK:
    Less than 12 - 14 V



NG
REPLACE THE ROOF CONSOLE BOX ASSEMBLY
OK


3. CHECK WIRE HARNESS

  1. B169486E01
    Disconnect the mayday ECU unit connector N46 and roof console box connector Q16.

  1. Check for continuity between connector N46 terminal 20 and ground.

    OK:
    Greater than 1 MΩ

  1. Check for continuity between connector N46 terminal 20 and connector Q16 terminal 2.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS
OK


4. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


5. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← TL27 Key pad Not Detected (from Jun 2009)TL29 Key pad Circuit Power Short To Battery (Oct 2006 – May 2009) →