2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL44 End Call Button Stuck

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

The Toyota Link key pad is a resistor-encoded switch, which means that each button has a separate and different value resistor connected to it.
The mayday ECU uses a voltage divider circuit to determine which button has been pressed.
The ECU supplies a 12 V signal voltage to the roof console box connector on terminal 2. Whenever a button is pressed, the corresponding switch is closed and is connected to ground through a resistor. The mayday ECU monitors the voltage on terminal 13 which will change when any of the buttons are pressed.
When the End Call button is pressed, the voltage on terminal 13 of the mayday ECU unit connector N46 will be approximately 0.7 V. The ECU determines this voltage as an End Call button press.
If the End Call button is pressed to make a call, you will be connected to the Toyota Link Call Centre.
Pressing this button while a call is connected will disconnect the call. However, it will not disconnect a call while the call is ringing the Toyota Link phone number.
It is not possible for this button to disconnect an emergency call or a Toyota Link call that has been upgraded to an emergency call status.
DTC TL44 is set if the End Call button is pressed for longer than 10 seconds.

INSPECTION PROCEDURE


1. CHECK DTCs
  1. Turn the engine switch on (IG).

  1. Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.

  1. Select: Back / History DTC / Clear Current DTCs.

  1. Turn the engine switch off for 1 minute, then on (IG) again.

  1. Is DTC TL44 reset?



NO
THE PROBLEM IS INTERMITTENT, CHECK THE MAYDAY ECU, WIRE HARNESS AND CONNECTORS
YES


2. CHECK ROOF CONSOLE BOX BUTTON SIGNAL VOLTAGE

  1. B169481E02
    Connect a digital multimeter between roof console box connector Q16 terminal 9 and ground.

  1. Turn the engine switch on (IG).

  1. Press the End Call button.

  1. Measure the voltage.

    OK:
    0.7 V



NG
Go to step 4
OK


3. CHECK BUTTON SUPPLY VOLTAGE

  1. B169481E01
    Disconnect the roof console box connector Q16.

  1. Connect a digital multimeter between terminal 2 and ground.

  1. Turn the engine switch on (IG) and check for voltage.

    OK:
    12 - 14 V



NG
REPLACE THE ROOF CONSOLE BOX ASSEMBLY
OK


4. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


5. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← TL43 GSM Not Logged With Signal Strength Present (from Oct 2006)TL45 Toyota Link Button Stuck (from Oct 2006) →