TL45 Toyota Link Button Stuck
Diagnostic trouble codes · Vehicles built from Oct 2006
DESCRIPTION
The Toyota Link key pad is a resistor-encoded switch, which means that each button has a separate and different value resistor connected to it.The mayday ECU uses a voltage divider circuit to determine which button has been pressed.
The ECU supplies a 12 V signal voltage to the roof console box connector on terminal 2. Whenever a button is pressed, the corresponding switch is closed and is connected to ground through a resistor. The mayday ECU monitors the voltage on terminal 13 which will change when any of the buttons are pressed.
When the Toyota Link button is pressed, the voltage on terminal 13 of the mayday ECU unit N46 will be approximately 2.3 V. The ECU determines this voltage as an Toyota Link button press.
If the Toyota Link button is pressed to make a call, you will be connected to the Toyota Link Call Centre.
DTC TL45 is set if the Toyota Link button is pressed for longer than 10 seconds.
INSPECTION PROCEDURE
| 1. CHECK DTCs |
Turn the engine switch on (IG).
Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.
Select: Back / History DTC / Clear Current DTCs.
Turn the engine switch off for 1 minute, then on (IG) again.
Is DTC TL45 reset?
|
|
||||
| YES | |
| 2. CHECK ROOF CONSOLE BOX BUTTON SIGNAL VOLTAGE |
Connect a digital multimeter between roof console box connector Q16 terminal 9 and ground.

Turn the engine switch on (IG).
Press the End Call button and check for voltage.
- OK:
- 2.3 V
|
|
||||
| OK | |
| 3. CHECK BUTTON SUPPLY VOLTAGE |
Disconnect the roof console box connector Q16.

Connect a digital multimeter between terminal 2 and ground.
Turn the engine switch on (IG) and check for voltage.
- OK:
- 12 - 14 V
|
|
||||
| OK | |
| 4. CHECK MAYDAY ECU WIRE HARNESS |
Disconnect the mayday ECU connectors A and B.

Check for continuity between the mayday ECU unit connector N46 and connectors A and B.
- OK:
- Less than 1 Ω
|
|
||||
| OK | |
| 5. CHECK MAYDAY ECU CONNECTORS |
Are the mayday ECU connectors tight?
|
|
||||
| YES | ||
| ||
