PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| Symptom |
Suspected Area |
See page |
| System does not operate at all (self-check function does not operate) |
1. Clearance warning ECU power source circuit |
Click here
|
| 2. Clearance sonar main switch circuit |
Click here
|
|
| 3. Clearance warning ECU assembly |
- |
|
| Ultrasonic sensor (clearance sonar) does not operate (self-check function does not operate) |
1. Front clearance sonar sensor LH circuit |
Click here
|
| 2. Front clearance sonar sensor RH circuit |
Click here
|
|
| 3. Rear clearance sonar sensor LH circuit |
Click here
|
|
| 4. Rear clearance sonar sensor RH circuit |
Click here
|
|
| 5. Clearance warning ECU assembly |
- |
|
| Sonar detection operation is normal but buzzer operation is intermittent |
1. Clearance warning buzzer circuit |
Click here
|
| 2. Clearance warning ECU assembly |
- |
|
| Detection operation is normal but sonar displays do not appear on multi-information display |
1. Vehicle wire harness or connector (CAN communication) |
Click here
|
| 2. Clearance warning ECU assembly |
- |
|
| 3. Combination meter assembly |
- |
|
| Warning message is displayed on multi-information display and any of the clearance sonar indicators is blinking |
1. Front clearance sonar sensor circuit |
Click here
|
| 2. Rear clearance sonar sensor circuit |
Click here
|
|
| 3. Clearance warning ECU assembly |
- |
|
| Clearance sonar system does not operate |
1. Clearance sonar main switch circuit |
Click here
|
| 2. Clearance warning ECU power source circuit |
Click here
|
|
| 3. Vehicle wire harness or connector (CAN communication) |
Click here
|
|
| 4. Clearance warning ECU assembly |
- |
|
| Freeze condition is displayed as a result of self-check |
1. Remove ice, mud or snow from the ultrasonic sensor |
- |
| Combination meter operates normally, but detection operates when shift lever position is P, or detection does not operate when shift lever is not in P position |
1. Vehicle wire harness or connector (CAN communication) |
Click here
|
| 2. Clearance warning ECU assembly |
- |
|
| Combination meter operates normally but errors occur when vehicle speed exceeds 10 km/h (6 mph) |
1. Vehicle wire harness or connector (CAN communication) |
Click here
|
| 2. Clearance warning ECU assembly |
- |
|
| 3. Combination meter assembly |
- |
|
| System operates with shift lever not in R position, or does not operate with shift lever in R position (rear ultrasonic sensor) |
1. Vehicle wire harness or connector (CAN communication) |
Click here
|
| 2. Clearance warning ECU assembly |
- |
|
| Clearance sonar main switch indicator does not come on (Clearance sonar system normal operation) |
1. Indicator circuit |
Click here
|