Clearance Warning ECU Power Source Circuit
Circuit diagnosis · Vehicles built from Jun 2009
DESCRIPTION
When the clearance sonar main switch is turned on, power is sent to the clearance warning ECU assembly and the indicator on the switch comes on. The Toyota parking assist-sensor system starts operating according to this signal.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. INSPECT CLEARANCE WARNING ECU ASSEMBLY |
Disconnect the O30 connector from the clearance warning ECU assembly.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
O30-10 (IG) - O30-21 (E)
Ignition switch on (IG), clearance sonar main switch on
11 to 14 V
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE SONAR MAIN SWITCH) |
Disconnect the O30 connector from the clearance warning ECU assembly.
Disconnect the E73 connector from the clearance sonar main switch assembly.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
O30-10 (IG) - E73-3 (ECU)
Always
Below 1 Ω
O30-10 (IG) - Body ground
Always
10 kΩ or higher
O30-21 (E) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT CLEARANCE SONAR MAIN SWITCH ASSEMBLY |
Remove the clearance sonar main switch assembly.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
3 (ECU) - 6 (IG)
Clearance sonar main switch off
10 kΩ or higher
3 (ECU) - 6 (IG)
Clearance sonar main switch on
Below 1 Ω
| *1 |
Component without harness connected (Clearance Sonar Main Switch Assembly) |
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (CLEARANCE SONAR MAIN SWITCH ASSEMBLY - BATTERY) |
Disconnect the E73 connector from the clearance sonar main switch assembly.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
E73-6 (IG) - Body ground
Ignition switch on (IG)
11 to 14 V
|
|
||||
| OK | ||
| ||
