2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Clearance Warning ECU Power Source Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This circuit provides power to operate the clearance warning ECU.

WIRING DIAGRAM

B139260E09

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU IG NO. 1)
  1. Remove the ECU IG No. 1 fuse from the instrument panel junction block.

  1. Measure the resistance of the ECU IG No. 1 fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE (ECU IG NO. 1)
OK


2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY)
B139282E05
  1. Disconnect the O30 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    O30-15 (IG) - Body ground
    Engine switch on (IG)
    9 to 15 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BODY GROUND)

  1. B139282E06
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    O30-17 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Warning Buzzer Circuit (from Jun 2009)Clearance Warning ECU Power Source Circuit (from Jun 2009) →