2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

CLEARANCE SONAR SYSTEM 
Symptom
Suspected Area
See page
System does not operate at all (self-check function does not operate)
1. Clearance warning ECU power source circuit
Click here
2. Clearance sonar main switch circuit
Click here
3. Clearance warning ECU assembly
-
Ultrasonic sensor (clearance sonar) does not operate (self-check function does not operate)
1. Front clearance sonar sensor LH circuit
Click here
2. Front clearance sonar sensor RH circuit
Click here
3. Rear clearance sonar sensor LH circuit
Click here
4. Rear clearance sonar sensor RH circuit
Click here
5. Clearance warning ECU assembly
-
Sonar detection operation is normal but buzzer operation is intermittent
1. Clearance warning buzzer circuit
Click here
2. Clearance warning ECU assembly
-
Detection operation is normal but sonar displays do not appear on multi-information display
1. Vehicle wire harness or connector (CAN communication)
Click here
2. Clearance warning ECU assembly
-
3. Combination meter assembly
-
Warning message is displayed on multi-information display and any of the clearance sonar indicators is blinking
1. Front clearance sonar sensor circuit
Click here
2. Rear clearance sonar sensor circuit
Click here
3. Clearance warning ECU assembly
-
Clearance sonar system does not operate
1. Clearance sonar main switch circuit
Click here
2. Clearance warning ECU power source circuit
Click here
3. Vehicle wire harness or connector (CAN communication)
Click here
4. Clearance warning ECU assembly
-
Freeze condition is displayed as a result of self-check
1. Remove ice, mud or snow from the ultrasonic sensor
-
Combination meter operates normally, but detection operates when shift lever position is P, or detection does not operate when shift lever is not in P position
1. Vehicle wire harness or connector (CAN communication)
Click here
2. Clearance warning ECU assembly
-
Combination meter operates normally but errors occur when vehicle speed exceeds 10 km/h (6 mph)
1. Vehicle wire harness or connector (CAN communication)
Click here
2. Clearance warning ECU assembly
-
3. Combination meter assembly
-
System operates with shift lever not in R position, or does not operate with shift lever in R position (rear ultrasonic sensor)
1. Vehicle wire harness or connector (CAN communication)
Click here
2. Clearance warning ECU assembly
-
Clearance sonar main switch indicator does not come on (Clearance sonar system normal operation)
1. Indicator circuit
Click here
← OPERATION CHECK (from Jun 2009)PROBLEM SYMPTOMS TABLE (from Jun 2009) →