2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

HINT:
  1. Use these procedures to troubleshoot the clearance sonar system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Refer to HOW TO PROCEED WITH TROUBLESHOOTING (Click here).

    NEXT

    3.CHECK INITIAL CHECK FUNCTION
    1. Refer to the operation check (Click here).

      Result:
      Result
      Proceed to
      Symptom does not occur
      A
      Symptom occurs
      B


    B.
    A

    4.SYMPTOM SIMULATION
    1. Refer to HOW TO PROCEED WITH TROUBLESHOOTING (Click here).

    NEXT

    5.CHECK CAN COMMUNICATION SYSTEM*
    1. Refer to HOW TO PROCEED WITH TROUBLESHOOTING (Click here for LHD with Smart Entry and Start System, Click here for RHD with Smart Entry and Start System, Click here for RHD without Smart Entry and Start System.

      HINT:
      The clearance warning ECU is connected to the CAN communication system. Therefore, be sure to check that there are no problems in the CAN communication system before performing troubleshooting.

    NEXT

    6.PROBLEM SYMPTOMS TABLE
    1. Refer to the problem symptoms table (Click here).

    NEXT

    7.CIRCUIT INSPECTION
      NEXT

      8.IDENTIFICATION OF PROBLEM
        NEXT

        9.REPAIR OR REPLACE
          NEXT

          10.CONFIRMATION TEST
            NEXT

            ← SYSTEM DESCRIPTION (from Oct 2006)HOW TO PROCEED WITH TROUBLESHOOTING (from Jun 2009) →