REMOVAL
Removal / installation · Vehicles built Jun 2006 – May 2009
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
| 2.
DRAIN BRAKE FLUID |
 |
- NOTICE:
- If brake fluid leaks onto any painted surface of the vehicle, wash or remove it completely.
| 3.
REMOVE DISC BRAKE CYLINDER ASSEMBLY |
 |
- Remove the union bolt and gasket from the disc brake cylinder assembly, then disconnect the front brake flexible hose.
- Hold the front disc brake cylinder slide pin and remove the 2 bolts and disc brake cylinder assembly.
- NOTICE:
- Remove the disc brake cylinder assembly while holding both of the brake pads or the anti-squeal springs may fall off the brake pads.