2006-2011 Camry Aurion · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built Jun 2006 – May 2009


1. REMOVE FRONT BRAKE PAD
  1. Remove the 2 anti-squeal springs.

  1. Remove the 2 brake pads from the front disc brake cylinder mounting.


2. REMOVE FRONT ANTI-SQUEAL SHIM
  1. Remove the 2 front anti-squeal shims and the 2 pad wear indicators from each pad.


3. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Remove the 4 front disc brake pad support plates.


4. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING

  1. C132796
    Remove the 2 bolts and front disc brake cylinder mounting.


5. REMOVE NO. 1 FRONT DISC BRAKE CYLINDER SLIDE PIN

  1. C132798E03
    Remove the No. 1 front disc brake cylinder slide pin from the front disc brake cylinder mounting.


6. REMOVE NO. 2 FRONT DISC BRAKE CYLINDER SLIDE PIN
  1. Remove the No. 2 front disc brake cylinder slide pin from the front disc brake cylinder mounting.


7. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSHING

  1. C132797
    Using a screwdriver, remove the front disc brake cylinder slide bushing from the No. 2 front disc brake cylinder slide pin.

    NOTICE:
    Do not damage the No. 2 front disc brake cylinder slide pin.

    HINT:
    Tape the screwdriver tip before use.


8. REMOVE FRONT DISC BRAKE BUSHING DUST BOOT

  1. C132799E03
    Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.


9. REMOVE CYLINDER BOOT

  1. C132808
    Using a screwdriver, remove the cylinder boot set ring and the cylinder boot.

    NOTICE:
    Be careful not to damage the brake piston or cylinder.


10. REMOVE FRONT DISC BRAKE PISTON

  1. C111364E08
    Prepare a wooden plate to hold the front disc brake piston.

  1. Place the wooden plate between the front disc brake piston and the disc brake cylinder assembly.

  1. C132795
    Use compressed air to remove the front disc brake piston from the disc brake cylinder assembly.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Do not spatter the brake fluid.


11. REMOVE PISTON SEAL

  1. C132807
    Using a screwdriver, remove the piston seal from the disc brake cylinder assembly.

    NOTICE:
    Do not damage the inner cylinder or cylinder groove.

    HINT:
    Tape the screwdriver tip before use.


12. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
  1. Remove the front disc brake bleeder plug cap.


13. REMOVE FRONT DISC BRAKE BLEEDER PLUG

14. REMOVE FRONT DISC

  1. C132801E01
    Remove the front disc.

    HINT:
    Put matchmarks on the disc and the axle hub.

← REMOVAL (Jun 2006 – May 2009)INSPECTION (Jun 2006 – Sep 2006) →