REASSEMBLY
Removal / installation · Vehicles built from Jun 2009
| 1. INSTALL FRONT DISC |
Align the matchmarks and install the front disc.

- NOTICE:
- When replacing the disc with a new one, select the installation position where the front disc has the minimum runout.
| 2. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG |
Temporarily tighten the front disc brake bleeder plug to the disc brake cylinder assembly.
| 3. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP |
Install the bleeder plug cap to the front disc brake bleeder plug.
| 4. INSTALL PISTON SEAL |
Apply lithium soap base glycol grease to a new piston seal.
Install the piston seal to the disc brake cylinder assembly.
| 5. INSTALL CYLINDER BOOT |
Apply lithium soap base glycol grease to the piston and a new cylinder boot.

Install the cylinder boot to the piston as shown in the illustration.
| 6. INSTALL FRONT DISC BRAKE PISTON |
Install the boot securely to the grooves of the cylinder.
Push in the piston by hand and install the boot onto the grooves of the piston.

- NOTICE:
- Install the boot securely to the grooves of the piston.
| 7. INSTALL FRONT DISC BRAKE BUSHING DUST BOOT |
Apply lithium soap base glycol grease to the seal surface of 2 new front disc brake bushing dust boots.

Install the 2 front disc brake bushing dust boots to the front disc brake cylinder slide pin.
| 8. INSTALL FRONT DISC BRAKE CYLINDER SLIDE PIN |
Apply lithium soap base glycol grease to the sliding part and the seal surface of the front disc brake cylinder slide pin.
Install the front disc brake cylinder slide pin to the bottom side of the front disc brake cylinder mounting.

Install the 2 front disc brake bushing dust boots to the groove of the front disc brake cylinder mounting.
| 9. INSTALL FRONT DISC BRAKE CYLINDER MOUNTING |
Install the cylinder mounting with the 2 bolts.

- Torque:
- 107 N*m{ 1,090 kgf*cm , 79 ft.*lbf }
| 10. INSTALL FRONT DISC BRAKE PAD SUPPORT PLATE |
Install the front disc brake pad support plate.
| 11. INSTALL FRONT BRAKE PAD |
Install the 2 front brake pads to the front disc brake cylinder mounting.

