2006-2011 Camry Aurion · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/o Rear Lower Spoiler)

  1. B137209
    Remove the 3 screws and rear quarter panel mudguard sub-assembly LH.


2. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH (w/o Rear Lower Spoiler)

HINT:
Use the same procedure for the RH side and LH side.


3. REMOVE REAR BUMPER ASSEMBLY (w/o Rear Lower Spoiler)

  1. B137211E01
    Put protective tape around the rear bumper assembly.

  1. B137212
    Using a screwdriver, open the 2 rear bumper plates.

    HINT:
    Tape the screwdriver tip before use.

  1. B137214
    Remove the 6 screws and 2 clips.

  1. B137215
    Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the rear bumper assembly.


4. REMOVE REAR FLOOR BOARD (w/ Rear Lower Spoiler)

  1. B138885E01
    Remove the 4 screws, 2 clips, 3 nuts and rear floor board.


5. REMOVE REAR BUMPER ASSEMBLY (w/ Rear Lower Spoiler)

  1. B146330E01
    Put protective tape around the rear bumper assembly.

  1. B146331
    Using a screwdriver, open the 2 rear bumper plates.

    HINT:
    Tape the screwdriver tip before use.

  1. B140154
    Remove the 6 screws.

  1. B146332
    Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the rear bumper assembly.

← COMPONENTS (from Jun 2009)REMOVAL (from Jun 2009) →