HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
- HINT:
- Use the following procedures to troubleshoot the lighting system.
- *: Use the intelligent tester.
- Use the following procedures to troubleshoot the lighting system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 4.INSPECT CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
- Result:
Result
Proceed to
CAN Communication System DTC is not output
A
CAN Communication System DTC is output
B
|
|||||
| |||||
| 5.CHECK FOR DTC* |
- Result:
Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here)
Terminals of ECU (Click here)
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
| |||||