CUSTOMIZE PARAMETERS
Troubleshooting · Vehicles built from Oct 2006
- HINT:
- The following items can be customized.
- NOTICE:
- Before attempting to customize vehicle settings, confirm whether it is possible to make the change that the customer has requested.
- Be sure to record the current value before customizing.
- In case of performing the troubleshooting, pay attention because there is a possibility that the function has been disabled by customizing. (Example: In case of the symptom in which "The wireless operation does not function", check that the wireless operation has not been disabled by customizing, then perform the troubleshooting.)
- Before attempting to customize vehicle settings, confirm whether it is possible to make the change that the customer has requested.
| Display |
Default |
Contents |
Setting |
| Lighting Time |
15 s |
Changes the lighting time of the interior light and ignition key cylinder light/engine switch illumination after closing all of the doors. |
7.5 s / 15 s / 30 s |
| Light Control |
ON |
Dims (ON setting) or turns off (OFF setting) the footwell illumination and inside handle illumination under the following conditions: ignition switch on (IG), shift lever not in P, and all doors closed. |
ON / OFF |
| I/L ON W/Door Key Unlock |
ON |
Lights up the interior light and ignition key cylinder light/engine switch illumination when a door is unlocked. |
ON / OFF |
| I/L when ACC OFF |
ON |
Lights up the interior light and ignition key cylinder light/engine switch illumination when the ignition switch is turned from on (ACC) to off. |
ON / OFF |
| Display |
Default |
Contents |
Setting |
| Response Time |
0.15 s |
Changes the delay timing of lighting the taillight when going into a tunnel in case the light control switch is in the AUTO position. |
1 s / 0.15 s |
| Sensitivity |
NORMAL |
Adjusts the sensitivity of the automatic light control system. |
LIGHT2 / LIGHT1 / NORMAL / DARK1 / DARK2 |
| Disp Ex ON Sen |
NORMAL |
Changes the ambient brightness level required to dim the clock display illumination, etc. |
LIGHT2 / LIGHT1 / NORMAL / DARK1 / DARK2 |
| Disp Ex OFF Sen |
NORMAL |
Changes the ambient brightness level required to cancel the dimming of the clock display illumination, etc. |
LIGHT2 / LIGHT1 / NORMAL / DARK1 / DARK2 |