HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
- HINT:
- Use the following procedures to troubleshoot the engine immobiliser system.
- Use the following procedures to troubleshoot the engine immobiliser system.
- The intelligent tester should be used in steps 4 and 6.
- The intelligent tester should be used in steps 4 and 6.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK |
- HINT:
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- The following 5 items are important points in the problem analysis:
What
Vehicle model, system name
When
Date, time, occurrence frequency
Where
Road conditions
Under what conditions?
Running conditions, driving conditions, weather conditions
How did it happen?
Problem symptoms
| |||||
| 3.CRANK ENGINE FOR MORE THAN 10 SECONDS |
| |||||
| 4.CHECK FOR DTCS |
Check for DTCs and note any codes that are output (Click here).
Delete the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to duplicate the SFI system DTC or engine immobiliser system DTC by simulating the symptoms indicated by the DTCs.
- Result:
Result
Proceed to
DTC output does not recur
A
SFI system DTC output recurs
B
(Click here for 2GR-FE)
(Click here for 2AZ-FE)
Engine immobiliser system DTC output recurs
C
(Click here)
|
|||||
|
|||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING |
DATA LIST/ACTIVE TEST (Click here)
TERMINALS OF ECU (Click here)
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
| |||||