2006-2011 Camry Aurion · Service Manual HEATER & AIR CONDITIONING SYSTEM

IG Power Source Circuit

Circuit diagnosis · Vehicles built from Oct 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006

DESCRIPTION

The main power source is supplied to the A/C amplifier when the ignition switch is turned on (IG).
The power source is used for operating the A/C amplifier and servo motor, etc.

WIRING DIAGRAM

E124493E06

INSPECTION PROCEDURE

HINT:
Start the engine before inspection. Check the IG1 relay or battery if the engine does not start.


1. INSPECT FUSE (A/C NO. 2)

  1. E124481E02
    Remove the A/C No. 2 fuse from the instrument panel J/B.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Item
    Condition
    Specified Condition
    A/C No. 2 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE (A/C NO. 2)
OK


2. INSPECT AIR CONDITIONING AMPLIFIER (IG+ - GND)

  1. E124471E09
    Remove the A/C amplifier with its connectors still connected.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E38-1 (IG+) - E38-14 (GND)
    Ignition switch on (IG)
    10 to 14 V



NG
Go to step 3
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

3. CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BATTERY)

  1. E124470E15
    Disconnect the A/C amplifier connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E38-1 (IG+) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BODY GROUND)

  1. E124470E11
    Disconnect the A/C amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E38-14 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER


← IG Power Source Circuit (Jun 2006 – Sep 2006)Back-up Power Source Circuit (from Jun 2006) →