2006-2011 Camry Aurion · Service Manual SECURITIES

B278A Short to GND in Immobiliser System Power Source Circuit

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This DTC is output when the engine switch power source supply line is open or shorted.
DTC No.
DTC Detection Condition
Trouble Area
B278A
Engine switch power source supply line is open or shorted
  1. Wire harness
  1. Engine switch
  1. Certification ECU

WIRING DIAGRAM

B139292E02

INSPECTION PROCEDURE

NOTICE:
If the certification ECU is replaced, register the key and ECU communication ID.


1. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    Result:
    Result
    Proceed to
    B278A output recurs
    A
    B278A output does not recur
    B



B
USE SIMULATION METHOD TO CHECK
A


2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE SWITCH)

  1. B119109E11
    Disconnect the E58 ECU and E52 switch connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E58-30 (VC5) - E52-14 (VC5)
    Below 1 Ω
    E58-40 (AGND) - E52-8 (AGND)
    E58-17 (E) - Body ground
    E58-30 (VC5) - Body ground
    10 kΩ or higher
    E58-40 (AGND) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (ENGINE SWITCH POWER SOURCE)

  1. B128349E06
    Reconnect the E58 ECU and E52 switch connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E58-30 (VC5) - Body ground
    Key is not in cabin
    Below 1 V
    Engine switch pressed
    4.6 to 5.4 V



NG
REPLACE CERTIFICATION ECU
OK


4. CHECK HARNESS AND CONNECTOR (ENGINE SWITCH BODY GROUND)

  1. B128349E07
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E58-40 (AGND) - Body ground
    Below 1 Ω

    Result:
    Result
    Proceed to
    NG
    A
    OK (for 2GR-FE)
    B
    OK (for 2AZ-FE)
    C



B
REPLACE ENGINE SWITCH (Click here)

C
REPLACE ENGINE SWITCH (Click here)
A

REPLACE CERTIFICATION ECU


← B278A Short to GND in Immobiliser System Power Source Circuit (Oct 2006 – May 2009)B2790 ID BOX EEPROM Malfunction (from Oct 2006) →