2006-2011 Camry Aurion · Service Manual BODY

Sliding Roof ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Oct 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006

DESCRIPTION

The sliding roof drive gear sub-assembly (sliding roof control ECU) receives signals from the sliding roof switch and activates the sliding roof. However, malfunctions in the fuse, wire harness or sliding roof drive gear sub-assembly (sliding roof control ECU) may cause the sliding roof system to stop operating.

WIRING DIAGRAM

B131102E05

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIDING ROOF OPERATION)
  1. Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the sliding roof slides open/close and tilts up/down.

    SLIDE ROOF:
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Slide Roof
    (Slide Roof)
    Operate sliding roof SLIDE CLOSE/TILT UP
    CLOS/UP: Sliding roof SLIDE CLOSE or TILT UP operation occurs.
    OFF: Sliding roof is not operating
    -
    Slide Roof
    (Slide Roof)
    Operate sliding roof SLIDE OPEN/TILT DOWN
    OPN/DWN: Sliding roof SLIDE OPEN or TILT DOWN operation occurs
    OFF: Sliding roof is not operating
    -
    OK:
    Sliding roof operates normally.



NG
Go to step 2
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF CONTROL ECU)

2. INSPECT FUSE (S/ROOF, ECU-IG NO. 1)
  1. Remove the S/ROOF and ECU-IG No. 1 fuses from the instrument panel J/B.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3. CHECK WIRE HARNESS (SLIDING ROOF CONTROL ECU - BATTERY AND BODY GROUND)

  1. B130117E07
    Disconnect the Q12 connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    B (Q12-1) - Body ground
    Always
    10 to 14 V
    IG (Q12-5) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    IG (Q12-5) - Body ground
    Ignition switch off
    Below 1 V

    Standard resistance:
    Tester Connection
    Specified Condition
    E (Q12-2) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF CONTROL ECU)


← Sliding Roof ECU Power Source Circuit (Jun 2006 – Sep 2006)COMPONENTS (Jun 2006 – Sep 2006) →