2006-2011 Camry Aurion · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE FRONT SEAT HEADREST ASSEMBLY

2. REMOVE OUTER SEAT TRACK BRACKET COVER
  1. Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.

  1. B147681
    Using a screwdriver, disengage the 4 claws and remove the front seat rear outer track bracket cover.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE INNER SEAT TRACK BRACKET COVER
  1. Using a screwdriver, disengage the 4 claws and remove the front seat rear inner track bracket cover.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE FRONT SEAT ASSEMBLY
  1. Operate the power seat switch knob and move the seat to the rearmost position.

  1. B147683
    Remove the 2 bolts on the front seat track bracket.

  1. Operate the power seat switch knob and move the seat to the position farthest forward.

  1. B147684
    Remove the 2 bolts on the rear seat track bracket.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent the airbag and seat belt pretensioner from deploying (Click here).

  1. Disconnect the connectors under the seat. Then remove the front seat assembly.

← REMOVAL (Oct 2006 – May 2009)DISASSEMBLY (Oct 2006 – May 2009) →