CAN Bus Line
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
DESCRIPTION
When any DTC of the CAN communication system is output, first measure the resistance between the terminals of the DLC3 to confirm the trouble area.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Turn the ignition switch off before measuring the resistances of CAN main wires and CAN branch wires.
- After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
- Turn the ignition switch off before measuring the resistances of CAN main wires and CAN branch wires.
- HINT:
- Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
| 1. CHECK CAN BUS WIRE (MAIN BUS WIRE FOR DISCONNECTION, BUS WIRES FOR SHORT CIRCUIT) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
E10-6 (CANH) - E10-14 (CANL)
Ignition switch off
54 to 69 Ω
- Result:
Result
Proceed to
OK
A
69 Ω or higher
B
Below 54 Ω
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK CAN BUS WIRE (SHORT TO B+ IN CAN BUS WIRE) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
E10-6 (CANH) - E10-16 (BAT)
Ignition switch off
6 kΩ or higher
E10-14 (CANL) -
E10-16 (BAT)
Ignition switch off
6 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK CAN BUS WIRE (SHORT TO GND IN CAN BUS WIRE) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
E10-4 (CG) - E10-6 (CANH)
Ignition switch off
200 Ω or higher
E10-4 (CG) - E10-14 (CANL)
Ignition switch off
200 Ω or higher
|
|
||||
| OK | ||
| ||
