When any DTC of the CAN communication system is output, first measure the resistance between the terminals of the DLC3 to confirm the trouble area.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.
HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
1. CHECK CAN BUS WIRE (MAIN BUS WIRE FOR DISCONNECTION, BUS WIRES FOR SHORT CIRCUIT)
Turn the engine switch off.
Measure the resistance according to the value(s) in the table below.