2006-2011 Camry Aurion · Service Manual SECURITIES

ID Code Box Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This circuit provides power to operate the ID code box.

WIRING DIAGRAM

B255123E01

INSPECTION PROCEDURE

NOTICE:
If the ID code box is replaced, register the key and ECU communication ID.


1. INSPECT FUSE (EFI NO. 1)
  1. Remove the EFI No. 1 fuse from the No. 1 engine room R/B.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY)

  1. B107455E17
    Disconnect the E50 ID code box connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    E50-1 (+B) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (ID CODE BOX - BODY GROUND)

  1. B107455E18
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E50-8 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← ID Code Box Power Source Circuit (Oct 2006 – May 2009)Certification ECU Power Source Circuit (Oct 2006 – May 2009) →