2006-2011 Camry Aurion · Service Manual SECURITIES

Certification ECU Power Source Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This circuit provides power to operate the certification ECU.

WIRING DIAGRAM

B128353E02

INSPECTION PROCEDURE

NOTICE:
If the certification ECU is replaced, register the key and ECU communication ID.


1. INSPECT FUSE (EFI NO. 1)
  1. Remove the EFI No. 1 fuse from the No. 1 engine room R/B.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK WIRE HARNESS (CERTIFICATION ECU - BATTERY)
B107456E47
  1. Disconnect the E58 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    E58-1 (+B) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BODY GROUND)

  1. B107456E40
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E58-17 (E) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← ID Code Box Power Source Circuit (from Jun 2009)Certification ECU Power Source Circuit (from Jun 2009) →