2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Yaw Rate Sensor Communication Stop Mode

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
Yaw Rate Sensor Communication Stop Mode
  1. "Yaw Rate/Decelerate Sensor" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Yaw Rate Sensor Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the yaw rate sensor
  2. Yaw rate sensor branch wire or connector
  3. Yaw rate sensor

HINT:
"Yaw Rate/Decelerate Sensor" refers to the circuit that includes the yaw rate sensor.


WIRING DIAGRAM

C133290E06

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN BUS WIRE (YAW RATE SENSOR BRANCH WIRE)
  1. Turn the engine switch off.

  1. C225736E01
    Disconnect the yaw rate sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E34-2 (CANH) - E34-3 (CANL)
    Engine switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN NO. 1 BUS BRANCH WIRE OR CONNECTOR (YAW RATE SENSOR BRANCH WIRE)
OK


2. CHECK WIRE HARNESS (POWER SOURCE CIRCUIT)

  1. C225736E03
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E34-4 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Value
    E34-1 (IG) - Body ground
    Engine switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE YAW RATE AND ACCELERATION SENSOR


← Steering Angle Sensor Communication Stop Mode (from Oct 2006)ECM Communication Stop Mode (Oct 2006 – May 2009) →