ECM Communication Stop Mode
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| ECM Communication Stop Mode |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
- After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
- Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
- HINT:
- Operating the engine switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
| 1. CHECK CAN BUS LINE FOR DISCONNECTION (ECM MAIN BUS WIRE) |
Disconnect the ECM connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Value
A24-41 (CANH) - A24-49 (CANL)
Ignition switch off
108 to 132 Ω
|
|
||||
| OK | |
| 2. CHECK ECM POWER SOURCE CIRCUIT |
Check the ECM power source circuit (Click here).
|
|
||||
| OK | ||
| ||
