AFS OFF Switch Circuit
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
When the AFS switch is pushed (ON), the AFS ECU will cancel the intelligent AFS control and turn on the AFS OFF indicator light.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester main switch on.
Select the item below in the DATA LIST, and read its value displayed on the intelligent tester.
AFS (AFS ECU): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
AFS OFF SW
AFS OFF switch signal ON / OFF
ON: AFS OFF switch pushed
OFF: AFS OFF switch not pushed
-
|
|
||||
| NG | |
| 2. INSPECT AFS OFF SWITCH |
- HINT:
- (Click here)
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (AFS OFF SWITCH - AFS ECU AND BODY GROUND) |
Disconnect the A61 AFS ECU connector.

Disconnect the E69 or E98 AFS OFF switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A61-32 (MSW) - E69-4 or E98-4
Always
Below 1 Ω
E69-1 or E98-1 - Body ground
Always
Below 1 Ω
A61-32 (MSW) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
