2006-2011 Camry Aurion · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. INSTALL PLANETARY GEAR

  1. A197679E01
    Apply high-temperature grease to the planetary gears and pin parts of the planetary shaft.

  1. Install the 3 planetary gears.


2. INSTALL RUBBER SEAL

  1. A194763
    Install the rubber seal to the repair service starter kit.


3. INSTALL STARTER ARMATURE ASSEMBLY

  1. A197678E01
    Apply high-temperature grease to the washer and the armature shaft.

  1. A194762E01
    Install the starter armature to the starter commutator end frame.

  1. Install the washer.

  1. Using snap ring pliers, securely install a new snap ring to the armature shaft groove.

    NOTICE:
    1. Be sure to install the snap ring in the armature shaft groove securely.
    2. Be sure to properly install the snap ring because it expands easily.

  1. A194767E01
    Using a vernier caliper, measure the length of the snap ring.

    Maximum length:
    5.0 mm (0.197 in.)

    If the length is more than the maximum, replace the snap ring with a new one.


4. INSTALL STARTER COMMUTATOR END FRAME COVER

  1. A197189
    Install the starter commutator end frame cover to the starter commutator end frame.


5. INSTALL STARTER ARMATURE PLATE

  1. A194768E01
    Insert the armature plate into the starter yoke.

  1. Align the keyway of the starter armature plate with the key inside the starter yoke, and install the starter armature plate.


6. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY

  1. A197184E01
    Align the rubber of the end frame with the cutout of the starter yoke.

  1. Install the starter commutator end frame to the starter yoke.

    NOTICE:
    The magnet of the starter yoke may attract the starter armature when the starter commutator end frame is installed, causing the magnet to break.


7. INSTALL STARTER YOKE ASSEMBLY

  1. A197185E01
    Align the protrusion of the starter yoke with the cutout of the repair service starter kit.

  1. A194758
    Install the starter yoke with the 2 through bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


8. INSTALL MAGNET STARTER SWITCH ASSEMBLY

  1. A197681E01
    Apply high-temperature grease to the plunger and the lever.

  1. A197186
    Pull the pinion gear and push down the lever.

  1. A197187E01
    Temporarily install the magnet starter switch by hooking the plunger into the upper side of the pinion drive lever.

  1. A194757
    Install the magnet starter switch with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. A194756
    Connect the lead wire to the magnet starter switch with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

← REASSEMBLY (Jun 2006 – May 2009)INSTALLATION (Jun 2006 – Sep 2006) →