2006-2011 Camry Aurion · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. INSTALL PLANETARY GEAR

  1. A081656E06
    Apply high-temperature grease to the planetary gears and pin parts of the planetary shaft.

  1. Install the 3 planetary gears to the motor terminal starter kit.


2. INSTALL STARTER ARMATURE ASSEMBLY

  1. A082440E08
    Apply high-temperature grease to the plate washer and the armature shaft.

  1. Install the starter armature assembly to the starter commutator end frame assembly.

  1. Using snap ring pliers, install the plate washer and a new snap ring.

  1. A058810E14
    Using vernier calipers, measure the snap ring.

    Maximum length:
    5.0 mm (0.197 in.)

    If the length is greater than the maximum, replace the snap ring with a new one.


3. INSTALL STARTER COMMUTATOR END FRAME COVER

  1. A081178E03
    Install the starter commutator end frame cover to the starter commutator end frame assembly.


4. INSTALL STARTER ARMATURE PLATE

  1. A073991E14
    Align the claw of the armature plate with the groove inside the starter yoke assembly, and install the starter armature plate.


5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY

  1. A079727E08
    Align the starter commutator end frame rubber with the groove of the starter yoke assembly.

  1. Install the starter commutator end frame assembly to the starter yoke assembly.

    NOTICE:
    The magnet of the starter yoke assembly may attract the starter armature assembly when the starter commutator end frame assembly is installed, causing the magnet to break.


6. INSTALL STARTER YOKE ASSEMBLY

  1. A079728E07
    Align the claw of the starter yoke with the groove inside the motor terminal starter kit.

  1. A079720E06
    Install the starter yoke with the 2 through bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


7. INSTALL REPAIR SERVICE STARTER KIT

  1. A079729E03
    Apply high-temperature grease to the plunger and the hook.

  1. Hang the plunger hook of the repair service starter kit to the drive lever hook.

  1. Install the plunger and the return spring.

  1. A079719E06
    Install the repair service starter kit with the 2 screws.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. A079718E06
    Connect the lead wire to terminal C with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

← INSPECTION (from Jun 2009)REASSEMBLY (from Jun 2009) →