2006-2011 Camry Aurion · Service Manual STEERING

B2782 Power Source Control ECU Malfunction

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

The main body ECU (*) controls the power supply to activate the steering lock motor. This prevents the steering from being locked while the vehicle is moving.

HINT:
*: The power source control ECU is not a physical part. This code refers to the power source control function performed by the main body ECU.

DTC No.
DTC Detecting Condition
Trouble Area
B2782
Steering lock motor drive control circuit is defective.
  1. Wire harness
  2. Steering lock actuator assembly (Steering lock ECU)
  3. Main body ECU

WIRING DIAGRAM

C113485E03

INSPECTION PROCEDURE


1. INSPECT STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)

  1. C106483E22
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E51-3 (IGE) - E51-1 (GND)
    The specified condition should be checked after performing the following:
    1. Turn the engine switch off
    2. Turn the engine switch on (ACC or IG)
    1. Motor activated: Below 1 V
    2. Motor not activated: 10 to 12 V
    E51-3 (IGE) - E51-1 (GND)
    The specified condition should be checked after performing the following:
    1. Move the shift lever to the P position
    2. Turn the engine switch off
    3. Open the driver's door
    1. Motor activated: Below 1 V
    2. Motor not activated: 10 to 12 V

    HINT:
    The steering lock ECU and steering lock actuator assembly are supplied as a unit.



OK
REPLACE STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)
NG


2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BODY GROUND)

  1. C106484E28
    Disconnect the E51 connector from the steering lock actuator assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E51-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - MAIN BODY ECU)

  1. C113502E01
    Disconnect the E7 connector from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E51-3 (IGE) - E7-19 (SLR+)
    Always
    Below 1 Ω
    E51-3 (IGE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← B2781 Open / Short in Steering Lock ECU (from Oct 2006)B2788 IG2 Signal Malfunction (from Oct 2006) →