2006-2011 Camry Aurion · Service Manual STEERING

B2788 IG2 Signal Malfunction

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

The steering lock ECU receives power from the IG2 relay. When the digital signal from the certification ECU and the voltage from the IG2 relay are received by the steering lock ECU, the steering will be unlocked. The steering lock ECU will not lock the steering when power from the IG2 relay is present (this prevents the steering from being locked while the vehicle is moving).
DTC No.
DTC Detecting Condition
Trouble Area
B2788
Different information is obtained from IG2 signals received directly from the IG2 circuit, and from IG2 signals sent via LIN communication for a period of 1 second.
  1. IG2 relay
  2. Wire harness
  3. Main body ECU
  4. Steering lock actuator assembly (Steering lock ECU)

WIRING DIAGRAM

C113505E02

INSPECTION PROCEDURE


1. INSPECT IGNITION RELAY NO. 2

  1. B060778E92
    Remove the IG2 relay from the engine room R/B.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Always
    10 kΩ or higher
    3 - 5
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω



NG
REPLACE IGNITION RELAY NO. 2
OK


2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BODY GROUND)

  1. C106484E29
    Disconnect the E51 connector from the steering lock actuator assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E51-1 (GND) - Body ground
    Always
    Below 1 Ω
    E51-2 (SGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BATTERY)

  1. C106484E30
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E51-6 (IG2) - E51-1 (GND)
    Engine switch on (IG)
    10 to 14 V
    E51-6 (IG2) - E51-2 (SGND)
    Engine switch on (IG)
    10 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    *E51-6 (IG2) - E51-7 (B)
    Engine switch off
    10 kΩ or higher

    *: This measurement is performed with the engine switch off to check for a short between IG2 and battery voltage.



OK
REPLACE STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)
NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BATTERY)


← B2782 Power Source Control ECU Malfunction (from Oct 2006)Steering Lock Motor Drive Power Circuit (from Oct 2006) →