2006-2011 Camry Aurion · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION
  1. Apply the parking brake and turn the ignition switch to the ON position.

  1. Depress the brake pedal and check that the engine starts only when the shift lever is set in the N or P position.

  1. Check that the back-up light comes on only when the shift lever is set in the R position and the light does not operate when the shift lever is in other positions.
    If a failure is found, check the park/neutral position switch.


INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

  1. C110340E36
    Jack up the vehicle.

  1. Disconnect the park/neutral position switch connector.

  1. Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.

    Standard resistance:
    Shift Position
    Tester Connection
    Specified Condition
    P
    2 - 6 and 4 - 5
    Below 1 Ω
    Except P
    10 kΩ or higher
    R
    2 - 1
    Below 1 Ω
    Except R
    10 kΩ or higher
    N
    2 - 9 and 4 - 5
    Below 1 Ω
    Except N
    10 kΩ or higher
    D and 4
    2 - 7
    Below 1 Ω
    Except D and 4
    10 kΩ or higher
    3
    2 - 3
    Below 1 Ω
    Except 3
    10 kΩ or higher
    2 and L
    2 - 8
    Below 1 Ω
    Except 2 and L
    10 kΩ or higher

    If operation cannot be done as specified, replace the park/neutral position switch.

← REMOVAL (from Jun 2009)INSPECTION (from Jun 2009) →