INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT UNDERDRIVE PACK CLEARANCE |
Install the underdrive clutch to the transaxle case.

- NOTICE:
- Be careful not to damage the oil seal rings.
Install a dial indicator as shown in the illustration.
Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
- Pack clearance:
- 1.51 to 1.71 mm (0.0594 to 0.0673 in.)
| INSPECT NO. 1 UNDERDRIVE CLUTCH DISC |
Check if the sliding surfaces of the discs, plates and flange are worn or burnt. If necessary, replace them.

- HINT:
- If the lining of a disc comes off or discolors, or even if a part of the groove is damaged, replace all discs.
- Before assembling new discs, soak them in ATF for at least 15 minutes.
- If the lining of a disc comes off or discolors, or even if a part of the groove is damaged, replace all discs.
| INSPECT UNDERDRIVE CLUTCH DRUM SUB-ASSEMBLY |
Using a dial indicator, measure the inside diameter of the underdrive clutch drum bushing.

- Standard inside diameter:
- 32.56 to 32.58 mm (1.2818 to 1.2826 in.)
- Maximum inside diameter:
- 32.63 mm (1.2846 in.)
| INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY |
Using vernier calipers, measure the free length of the spring together with the spring seat.

- Standard free length:
- 17.14 mm (0.6748 in.)
