2006-2011 Camry Aurion · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. REMOVE NO. 2 UNDERDRIVE CLUTCH FLANGE HOLE SNAP RING

  1. D003701E01
    Using a screwdriver, remove the No. 2 underdrive clutch flange hole snap ring.


2. REMOVE NO. 1 UNDERDRIVE CLUTCH DISC

  1. C134892E01
    Remove the flange, 3 discs, and 3 plates from the underdrive clutch drum.


3. REMOVE UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D003703E01
    Place SST on the clutch balancer and compress the spring with a press.
    SST
    09350-32014   (09351-32070)

  1. Using a snap ring expander, remove the snap ring.

    NOTICE:
    1. Stop the press when the spring seat is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove. This prevents the spring seat from being deformed.
    2. Do not expand the snap ring excessively.

  1. C056359E01
    Remove the clutch balancer from the underdrive clutch drum.

  1. C056360E04
    Remove the return spring from the underdrive clutch drum.


4. REMOVE UNDERDRIVE CLUTCH PISTON SET

  1. D003705
    Remove the underdrive clutch from the transaxle case.

    NOTICE:
    Be careful not to damage the oil seal ring.

  1. Holding the underdrive clutch piston by hand, apply compressed air (392 kPa, 4.0 kgf/cm 2, 57 psi) to the transaxle case to remove the underdrive clutch piston.


5. REMOVE UNDERDRIVE CLUTCH DRUM O-RING

  1. D026465E03
    Using a screwdriver, remove the O-ring from the underdrive clutch drum.

← COMPONENTS (from Jun 2006)INSPECTION (from Jun 2006) →