INSTALLATION
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL FRONT TRANSAXLE CASE COVER OIL SEAL |
 |
- Coat a new oil seal lip with MP grease.
Using SST and a hammer, install the oil seal.
- SST
- 09608-10010
09950-70010
(09951-07200)
- Installation depth:
- -0.5 to 0.5 mm (-0.020 to 0.020 in.)
- NOTICE:
- Be careful not to damage the oil seal lip.
| 2.
INSTALL TRANSMISSION CASE OIL SEAL |
 |
- Coat a new oil seal lip with MP grease.
Using SST and a hammer, install the oil seal.
- SST
- 09608-32010
09950-70010
(09951-07200)
- Installation depth:
- 3.0 to 4.0 mm (0.1181 to 0.1575 in.)
- NOTICE:
- Be careful not to damage the oil seal lip.
| 3.
INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
 |
Click here.
| 4.
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
 |
- HINT:
- Use the same procedures described for the LH side.
| 5.
INSTALL FRONT WHEELS |
 |
-
Torque:
- 103 N*m{
1,050 kgf*cm
, 76 ft.*lbf
}
| 6.
ADD MANUAL TRANSAXLE OIL |
 |
- Park the vehicle on a level place.
Remove the filler plug and gasket.
Check that the oil surface is within 5 mm (0.20 in.) below the lowest point of the filler plug opening.
- Oil grade:
- API GL-4 or GL-5
- Viscosity:
- SAE 75W-90
- NOTICE:
- Problems may occur if the oil level is too high or too low.
- After replacing the oil, drive the vehicle and check the oil level again.
- CAUTION:
- Oil may be hot take care not to scold your finger.
Check for oil leakage if the oil level is low.
Install the filler plug and a new gasket.
-
Torque:
- 49 N*m{
500 kgf*cm
, 36 ft.*lbf
}
| 7.
INSPECT MANUAL TRANSAXLE OIL |
|
| 8.
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
 |
Click here.
| 9.
CHECK ABS SPEED SENSOR SIGNAL |
 |
ABS: (Click here).VSC: (Click here).