2006-2011 Camry Aurion · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL FRONT TRANSAXLE CASE COVER OIL SEAL

  1. D025722E02
    Coat a new oil seal lip with MP grease.

  1. Using SST and a hammer, install the oil seal.

    SST
    09608-10010  
    09950-70010   (09951-07200)

    Installation depth:
    -0.5 to 0.5 mm (-0.020 to 0.020 in.)

    NOTICE:
    Be careful not to damage the oil seal lip.


2. INSTALL TRANSMISSION CASE OIL SEAL

  1. D026133E04
    Coat a new oil seal lip with MP grease.

  1. Using SST and a hammer, install the oil seal.

    SST
    09608-32010  
    09950-70010   (09951-07200)

    Installation depth:
    3.0 to 4.0 mm (0.1181 to 0.1575 in.)

    NOTICE:
    Be careful not to damage the oil seal lip.


3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Click here.

4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


5. INSTALL FRONT WHEELS

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


6. ADD MANUAL TRANSAXLE OIL

  1. D025304E01
    Park the vehicle on a level place.

  1. Remove the filler plug and gasket.

  1. Check that the oil surface is within 5 mm (0.20 in.) below the lowest point of the filler plug opening.

    Oil grade:
    API GL-4 or GL-5

    Viscosity:
    SAE 75W-90

    NOTICE:
    1. Problems may occur if the oil level is too high or too low.
    2. After replacing the oil, drive the vehicle and check the oil level again.

    CAUTION:
    Oil may be hot take care not to scold your finger.

  1. Check for oil leakage if the oil level is low.

  1. Install the filler plug and a new gasket.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


7. INSPECT MANUAL TRANSAXLE OIL

8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Click here.

9. CHECK ABS SPEED SENSOR SIGNAL
ABS: (Click here).
VSC: (Click here).
← INSTALLATION (Jun 2006 – Sep 2006)INSTALLATION (from Jun 2009) →