2006-2011 Camry Aurion · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. REMOVE 4TH GEAR

  1. C070515
    Hold the input shaft assembly in a vise using aluminum plates.

  1. Using 2 screwdrivers and a hammer, remove the input shaft rear bearing shaft snap ring from the input shaft.

    HINT:
    Use a shop rag or a piece of cloth to keep the snap ring from flying off.

  1. C092867E02
    Using SST and a press, remove the input shaft rear bearing and 4th gear.
    SST
    09950-00020  

    NOTICE:
    Do not overtighten the SST.


2. REMOVE 4TH GEAR NEEDLE ROLLER BEARING

  1. C069551
    Remove the 4th gear needle roller bearing from the input shaft.


3. REMOVE 2ND SYNCHRONIZER OUTER RING

  1. D031907
    Remove the 2nd synchronizer outer ring (No. 4 synchronizer ring) from the No. 2 transmission clutch hub.


4. REMOVE 4TH GEAR BEARING SPACER

  1. D031906
    Remove the 4th gear bearing spacer from the No. 2 transmission clutch hub.


5. REMOVE 3RD GEAR

  1. C069615
    Using 2 screwdrivers and a hammer, remove the No. 2 clutch hub setting shaft snap ring from the input shaft.

    HINT:
    Use a shop rag or a piece of cloth to keep the snap ring from flying off.

  1. D031908E02
    Using SST and a press, remove the No. 2 transmission clutch hub and 3rd gear from the input shaft.
    SST
    09950-00020  

    NOTICE:
    Do not overtighten the SST.


6. REMOVE 3RD GEAR NEEDLE ROLLER BEARING

  1. C069617
    Remove the 3rd gear needle roller bearing from the input shaft.


7. REMOVE NO. 3 SYNCHRONIZER RING

  1. C069618
    Remove the No. 3 synchronizer ring from the 3rd gear.


8. REMOVE NO. 2 TRANSMISSION HUB SLEEVE

  1. C069619
    Remove the No. 2 transmission hub sleeve, 3 No. 2 synchromesh shifting keys, and 3 No. 2 synchromesh shifting key springs from the No. 2 transmission clutch hub.

    HINT:
    Use a shop rag or a piece of cloth to keep the shifting keys and shifting key springs from flying off.


9. REMOVE INPUT SHAFT FRONT BEARING

  1. C092869E02
    Using SST and a press, remove the input shaft front bearing (inner race) from the input shaft.
    SST
    09950-00020  

    NOTICE:
    Do not overtighten the SST.

← COMPONENTS (from Jun 2006)INSPECTION (from Jun 2006) →