2006-2011 Camry Aurion · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. REMOVE CONTROL SHIFT LEVER BUSHING

  1. C069529
    Remove the control shift lever bushing from the No. 2 selecting bellcrank.


2. REMOVE NO. 1 SELECTING BELLCRANK DUST COVER

  1. C069530
    Remove the No. 1 selecting bellcrank dust cover from the No. 2 selecting bellcrank.


3. REMOVE SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY

  1. C069532
    Remove the nut, wave washer, and selecting bellcrank No. 2 plate washer from the No. 2 selecting bellcrank.

  1. C069799
    Remove the selecting bellcrank support sub-assembly from the No. 2 selecting bellcrank.


4. REMOVE NO. 2 SELECTING BELLCRANK DUST COVER

  1. C069531
    Remove the No. 2 selecting bellcrank dust cover from the No. 2 selecting bellcrank.


5. REMOVE SELECTING BELLCRANK NO. 2 BUSHING

  1. C069798
    Remove the selecting bellcrank bushing from the No. 2 selecting bellcrank.


6. REMOVE NO. 2 SHIFT LEVER INNER

  1. C138351
    Hold the shift and select lever in a vise using aluminum plates.

    NOTICE:
    Do not damage the shift and select lever shaft.

  1. Using a pin punch (φ 5 mm), remove the 2 shift inner lever slotted pins.

    NOTICE:
    Do not damage the shift and select lever shaft.

  1. Apply force to the No. 1 select return compression spring and No. 2 select return compression spring, then hold them in a vise using aluminum plates.

  1. C069535
    Using 2 screwdrivers and a hammer, remove the select spring No. 2 seat snap ring from the shift and select lever shaft.

    NOTICE:
    Do not damage the shift and select lever shaft.

  1. C135406
    Remove the No. 2 select spring seat, No. 2 select return compression spring, and No. 2 shift lever inner from the shift and select lever shaft.


7. REMOVE NO. 1 SELECT SPRING SEAT

  1. C069538
    Remove the shift inter lock plate, No. 1 select return compression spring and No. 1 select spring seat from the shift and select lever shaft.


8. REMOVE SHIFT INTERLOCK PLATE COVER

  1. C091167E06
    Remove the shift interlock plate cover from the shift interlock plate.


9. REMOVE NO. 1 SHIFT LEVER INNER

  1. C091169E07
    Remove the No. 1 shift lever inner from the shift interlock plate.


10. REMOVE SELECT SPRING NO. 1 SEAT SHAFT SNAP RING

  1. C069539
    Using 2 screwdrivers and a hammer, remove the select spring No. 1 seat shaft snap ring.

    NOTICE:
    Do not damage the shaft.


11. REMOVE CONTROL SHAFT COVER OIL SEAL

  1. D032770
    Using a screwdriver, remove the control shaft cover oil seal from the control shaft cover.

    HINT:
    Tape the screwdriver tip before use to avoid damage.

← COMPONENTS (from Jun 2006)REASSEMBLY (from Jun 2006) →