2006-2011 Camry Aurion · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. INSTALL CONTROL SHAFT COVER OIL SEAL

  1. C092886E02
    Using SST and a hammer, install a new control shaft cover oil seal to the control shaft cover.
    SST
    09950-60010   (09951-00280)
    09950-70010   (09951-07100)

    Oil seal installation depth:
    28.0 to 29.0 mm (1.1022 to 1.142 in.)


2. INSTALL SELECT SPRING NO. 1 SEAT SHAFT SNAP RING

  1. C069540
    Using a brass bar and a hammer, install the select spring No. 1 seat shaft snap ring.


3. INSTALL NO. 1 SHIFT LEVER INNER

  1. C091169E07
    Install the No. 1 shift lever inner to the shift interlock plate.


4. INSTALL SHIFT INTERLOCK PLATE COVER

  1. C091167E06
    Install the shift interlock plate cover to the shift interlock plate.


5. INSTALL NO. 1 SELECT SPRING SEAT

  1. C069538
    Install the No. 1 select spring seat, No. 1 select return compression spring, and shift interlock plate to the shift and select lever shaft.


6. INSTALL NO. 2 SHIFT LEVER INNER

  1. C135406
    Install the No. 2 shift lever inner, No. 2 select return compression spring and No. 2 select return spring seat to the shift and select lever shaft.

  1. Hold the shift and select lever in a vise using aluminum plates.

  1. Using a brass bar and a hammer, install the select seat snap ring to the shift and select lever shaft.

  1. C135405E01
    Using a pin punch (φ 5 mm) and a hammer, install the 2 shift inner lever slotted pins to the shift and select lever shaft.

    Clearance A:
    0.7 to 1.7 mm (0.0276 to 0.0669 in.)

    Clearance B:
    -0.4 to 0.5 mm (-0.0157 to 0.0197 in.)


7. INSTALL SELECTING BELLCRANK NO. 2 BUSHING

  1. C069798
    Coat the 2 selecting bellcrank No. 2 bushings with MP grease and install them to the No. 2 selecting bellcrank.


8. INSTALL NO. 2 SELECTING BELLCRANK DUST COVER

  1. C069531
    Coat the No. 2 selecting bellcrank dust cover with MP grease and install it to the No. 2 selecting bellcrank.


9. INSTALL SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY

  1. C069799
    Install the selecting bellcrank support sub-assembly to the No. 2 selecting bellcrank.

  1. C069532
    Install the No. 2 selecting bellcrank plate washer, washer, and nut.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


10. INSTALL NO. 1 SELECTING BELLCRANK DUST COVER

  1. C069530
    Install the No. 1 selecting bellcrank dust cover to the No. 2 selecting bellcrank.


11. INSTALL CONTROL SHIFT LEVER BUSHING

  1. C069529
    Install the control shift lever bushing to the No. 2 selecting bellcrank.

← DISASSEMBLY (from Jun 2006)COMPONENTS (from Jun 2006) →