HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.VEHICLE BROUGHT INTO A WORKSHOP |
| |||||
| 2.DIAGNOSTIC QUESTIONING AND SYMPTOM CONFIRMATION |
Ask the customer about symptoms and confirm malfunctions.
|
||||
|
| 3.CONFIRM THE SYSTEM NORMAL CONDITION |
|
||||
|
| 4.CHECK FOR DTC |
- HINT:
- If the system cannot enter the diagnostic mode, replace the navigation receiver assembly.
|
||||
|
| 5.DTC CLEAR |
Clear the DTCs and finish the diagnostic mode.
- HINT:
- The currently output DTCs may not indicate actual malfunctions depending on the vehicle conditions.
| |||||
| 6.RECHECK FOR DTC |
- HINT:
- Even if the malfunction symptom is not confirmed, check for diagnostic trouble codes. This is because the system stores past diagnostic trouble codes.
- Refer to the detailed description on the diagnostic screen as necessary (Click here).
- Check the diagnostic trouble code and inspect the area the code indicates.
- Even if the malfunction symptom is not confirmed, check for diagnostic trouble codes. This is because the system stores past diagnostic trouble codes.
|
||||
|
| 7.DIAGNOSTIC TROUBLE CODE CHART |
Find the output code in the diagnostic trouble code chart (Click here).
|
| 8.PROBLEM SYMPTOMS TABLE |
Find the applicable symptom in the problem symptoms table (Click here).
- HINT:
- If the symptom does not recur and no code is output, perform the symptom reproduction method (Click here).
|
||||
|
| 9.CHECK THE ECU TERMINAL ARRANGEMENT BASED ON THE MALFUNCTION SYMPTOM |
| |||||
| 10.CHECK THE CIRCUIT |
Adjust, repair, or replace as necessary.
| |||||
| 11.RECHECK FOR DIAGNOSTIC TROUBLE CODE |
- HINT:
- After deleting the DTCs, recheck for diagnostic trouble codes.
| |||||
| 12.PERFORM CONFIRMATION TEST |
| |||||