2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

HINT:
  1. Use the following procedure to troubleshoot the navigation system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.DIAGNOSTIC QUESTIONING AND SYMPTOM CONFIRMATION
    1. Ask the customer about symptoms and confirm malfunctions.

      Result:
      Result
      Proceed to
      Other symptoms
      A
      The screen displays nothing.
      B


    B.
    A

    3.OPERATION CHECK
    1. Refer to Check System Normal Condition (Click here).

      Result:
      Result
      Proceed to
      Symptom is not normal operation.
      A
      Symptom is normal operation.
      B


    B.
    A

    4.CHECK FOR DTC*
    1. Refer to DTC Check/Clear (Click here).

      Result:
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B


    B.
    A

    5.DTC CLEAR*
    1. Clear the DTCs and finish the diagnostic mode.

      HINT:
      The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.

    NEXT

    6.RECHECK FOR DTC*

      Result:
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B

      HINT:
      1. Even if the malfunction symptom is not confirmed, check for diagnostic trouble codes. This is because the system stores history diagnostic trouble codes.
      2. Refer to the detailed description on the diagnostic screen as necessary (Click here).
      3. Check the diagnostic trouble code and inspect the area code indicates.


    B.
    A

    7.DIAGNOSTIC TROUBLE CODE CHART
    1. Find the output code in Diagnostic Trouble Code Chart (Click here).


    NEXT.
    8.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table.
      A
      Fault is listed in Problem Symptoms Table.
      B

      HINT:
      If the symptom does not recur and no DTC is output, perform the symptom reproduction method (Click here).


    B.
    A

    9.CHECK ECU TERMINAL ARRANGEMENT BASED ON MALFUNCTION SYMPTOM
    1. Refer to Terminals of ECU (Click here).

    NEXT

    10.CHECK THE CIRCUIT
    1. Adjust, repair or replace as necessary.

    NEXT

    11.RECHECK FOR DIAGNOSTIC TROUBLE CODE*

      HINT:
      After clearing the DTCs, recheck for DTCs.

    NEXT

    12.PERFORM CONFIRMATION TEST
      NEXT

      ← HOW TO PROCEED WITH TROUBLESHOOTING (Oct 2006 – May 2009)IDENTIFICATION OF NOISE SOURCE (Jun 2006 – May 2009) →