REMOVAL
Removal / installation · Vehicles built from Jun 2006
- HINT:
- Use the same procedures for the RH side and the LH side.
- The procedures listed below are for the LH side.
| 2.
SEPARATE FRONT STABILIZER LINK ASSEMBLY |
 |
- Support the front suspension lower No. 1 arm with a jack using a wooden block.
- Remove the nut and separate the front stabilizer link assembly from the front shock absorber with coil spring.
- HINT:
- If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.
| 3.
REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING |
 |
- Loosen the lock nut of the front shock absorber with coil spring.
- NOTICE:
- Do not remove the lock nut.
- Only loosen the nut when disassembling the front shock absorber with coil spring.
- Remove the bolt and disconnect the front flexible hose and front speed sensor wire harness from the front shock absorber with coil spring.
- NOTICE:
- Be sure to remove the front speed sensor from the front shock absorber with coil spring.
- Remove the 2 nuts on the lower side of the front shock absorber with coil spring.
- NOTICE:
- When removing the nuts, keep the bolts from rotating.
- Keep the bolts inserted to secure the front axle assembly.
- Remove the 3 nuts on the upper side of the front shock absorber with coil spring.
- Remove the 2 bolts and front shock absorber with coil spring.
- NOTICE:
- Make sure that the front speed sensor is disconnected from the front shock absorber with coil spring.