INSTALLATION
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL NO. 1 FRONT STABILIZER BAR BUSHING |
 |
- Install the 2 No. 1 front stabilizer bar bushings to the outside of the bushing stopper on the front stabilizer bar.
- NOTICE:
- Make sure that the cutout of the front stabilizer bar bushing No. 1 faces the rear side as shown in the illustration.
| 2.
INSTALL NO. 1 FRONT STABILIZER BRACKET LH |
 |
Install the No. 1 front stabilizer bracket LH.
| 3.
INSTALL NO. 1 FRONT STABILIZER BRACKET RH |
 |
Install the No. 1 front stabilizer bracket RH.
| 4.
INSTALL FRONT STABILIZER BAR |
 |
- Install the front stabilizer bar with the 2 bolts. (LH Side)
-
Torque:
- 27 N*m{
275 kgf*cm
, 20 ft.*lbf
}
- Install the front stabilizer bar with the 2 bolts. (RH Side)
-
Torque:
- 27 N*m{
275 kgf*cm
, 20 ft.*lbf
}
| 5.
INSTALL ENGINE ASSEMBLY WITH TRANSAXLE |
 |
- HINT:
- Refer to the instructions for installation of the engine assembly (Click here for 2AZ-FE, Click here for 2GR-FE).
| 6.
INSTALL FRONT STABILIZER LINK ASSEMBLY LH |
 |
- Install the front stabilizer link assembly LH to the front stabilizer bar with the nut.
-
Torque:
- 74 N*m{
755 kgf*cm
, 55 ft.*lbf
}
- HINT:
- If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
| 7.
INSTALL FRONT STABILIZER LINK ASSEMBLY RH |
 |
- HINT:
- Perform the same procedures as for the LH side.
| 8.
CONNECT TIE ROD END SUB-ASSEMBLY
|
 |
Install the tie rod end sub-assembly to the steering knuckle with the nut.
-
Torque:
- 49 N*m{
500 kgf*cm
, 36 ft.*lbf
}
Install a new cotter pin.
- NOTICE:
- If the holes for the cotter pin are not aligned, tighten the nut up to 60° further.
| 9.
CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY
|
 |
- Align the matchmarks on the steering intermediate shaft and the power steering link assembly.
- Install the bolt.
-
Torque:
- 35 N*m{
360 kgf*cm
, 26 ft.*lbf
}
| 10.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
|
| 11.
INSTALL FRONT WHEELS |
 |
-
Torque:
- 103 N*m{
1,050 kgf*cm
, 76 ft.*lbf
}
| 12.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| 13.
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
 |
(Click here)