2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL NO. 1 FRONT STABILIZER BAR BUSHING

  1. C145489E01
    Install the 2 No. 1 front stabilizer bar bushings to the outside of the bushing stopper on the front stabilizer bar.

    NOTICE:
    Make sure that the cutout of the front stabilizer bar bushing No. 1 faces the rear side as shown in the illustration.


2. INSTALL NO. 1 FRONT STABILIZER BRACKET LH
  1. Install the No. 1 front stabilizer bracket LH.


3. INSTALL NO. 1 FRONT STABILIZER BRACKET RH
  1. Install the No. 1 front stabilizer bracket RH.


4. INSTALL FRONT STABILIZER BAR

  1. C143302E01
    Install the front stabilizer bar with the 2 bolts. (LH Side)

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }

  1. C143303E01
    Install the front stabilizer bar with the 2 bolts. (RH Side)

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }


5. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Refer to the instructions for installation of the engine assembly (Click here for 2AZ-FE, Click here for 2GR-FE).


6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

  1. C144426E02
    Install the front stabilizer link assembly LH to the front stabilizer bar with the nut.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.


7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedures as for the LH side.


8. CONNECT TIE ROD END SUB-ASSEMBLY
  1. Install the tie rod end sub-assembly to the steering knuckle with the nut.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

  1. Install a new cotter pin.

    NOTICE:
    If the holes for the cotter pin are not aligned, tighten the nut up to 60° further.


9. CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

  1. C156703E01
    Align the matchmarks on the steering intermediate shaft and the power steering link assembly.

  1. C156702E01
    Install the bolt.

    Torque:
    35 N*m{ 360 kgf*cm , 26 ft.*lbf }


10. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

11. INSTALL FRONT WHEELS

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

13. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← INSTALLATION (Jun 2006 – Sep 2006)INSTALLATION (from Jun 2009) →