Removal / installation · Vehicles built from Jun 2006
1.
INSTALL REAR STRUT ROD
Install the rear strut rod (rear side), bolt and nut, and temporarily tighten the bolt.
NOTICE:
When temporarily tightening the bolt, keep the nut from rotating.
Support the rear axle carrier.
Connect the rear strut rod (front side) with the bolt and nut.
NOTICE:
When temporarily tightening the bolt, keep the nut from rotating.
2.
STABILIZE SUSPENSION
Jack up the rear axle carrier, placing a wooden block to avoid damage. Apply load to the suspension so that the installed bolt of the rear No. 1 suspension arm (inner side of vehicle) is horizontally aligned with the center of the rear axle hub.
3.
FULLY TIGHTEN REAR STRUT ROD
Fully tighten the bolt.
Torque:
113 N*m{
1,152 kgf*cm
, 83 ft.*lbf
}
Fully tighten the bolt.
Torque:
113 N*m{
1,152 kgf*cm
, 83 ft.*lbf
}
4.
CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Install the No. 3 parking brake cable assembly with the bolt.